WindowsXP VPN Server

The following page details the steps necessary to create a WindowsXP VPN Server
1. Go to Start / Settings / Network Connections
2. Start the New Connection Wizard
xp_vpn_server1.jpg  
3. Click on the Next button
4. Select Set up advanced connection
xp_vpn_server2.jpg  
5. Click on the Next button.
6. Click on Accept incoming connections
xp_vpn_server3.jpg  
7. Click on the Next button
8. At the LPT1 page, skip it and just click on the Next button.
xp_vpn_server4.jpg  
9. Click on Allow virtual private connection
xp_vpn_server5.jpg  
10. Click on the Next button
11. Add user accounts that you want to be able to connect to your WindowsXP computer.
xp_vpn_server6.jpg  
12. Click on the Next button.
13. Highlight Internet Protocol (TCP/IP) and click on Properties
xp_vpn_server7.jpg  
14. Determine how you want the remote computers to get their IP address
xp_vpn_server8.jpg  
19. The above example will assign IP addresses to each client. Make sure the IP scheme is the same as on your server.
20. Submitted by Andy Bloss

If the VPN server is behind a router, Port Mapping will need to be done on the router. Standard port usage is 1723 for PPTP.  You might also need to configure your router for PPTP Passthrough. Port usage for IPSec is 500, 50-51. These ports will have to be forwarded to the VPN server's IP

轉載:http://www.onecomputerguy.com/networking/xp_vpn_server.htm

arrow
arrow
    全站熱搜

    mitblog 發表在 痞客邦 留言(0) 人氣()